TheCoatingStore.com

Results 1 to 4 of 4

Thread: High spots from PO body work

  1. #1

    Default High spots from PO body work

    A PO drilled holes to pull sheet metal on my rear 1/4 panel. Now that I've removed all the bondo there are high spots where the holes were drilled. What is suggested to knock them down??? Can I do the heat and cool method to shrink the metal? Any help will be greatly appreciated
    B3E7210E-3337-4398-A727-55BEA2139626.jpg722C6D4F-06EC-4493-BE46-C140E2D09790.jpg

  2. #2
    Join Date
    Feb 2006
    Posts
    189

    Default

    Quote Originally Posted by mellis18 View Post
    A PO drilled holes to pull sheet metal on my rear 1/4 panel. Now that I've removed all the bondo there are high spots where the holes were drilled. What is suggested to knock them down??? Can I do the heat and cool method to shrink the metal? Any help will be greatly appreciated
    B3E7210E-3337-4398-A727-55BEA2139626.jpg722C6D4F-06EC-4493-BE46-C140E2D09790.jpg
    If you can get to both sides, hammer and dolly should do the job. Are those still holes with filler in them, or are they metal patched?

  3. #3

    Default

    Quote Originally Posted by fj5gtx View Post
    If you can get to both sides, hammer and dolly should do the job. Are those still holes with filler in them, or are they metal patched?
    Cannot get behind this area. They have been filled with metal reinforced filler.

  4. #4
    Join Date
    Nov 2005
    Posts
    47,716

    Default

    Quote Originally Posted by mellis18 View Post
    Cannot get behind this area. They have been filled with metal reinforced filler.
    I'm sorry that I didn't see this post earlier but I'd probably just do some light tapping until the area is slightly low then grind and fill it until it's level.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •