Which honestly, could have been there before I did anything, but either way, I need it gone. Here is the culprit, looking down from the top. The bulbous wave is below the top body line you can see in the picture. It is a 67 Mustang. I have a square patch welded there all the way to the edge (Where the door joins it) as there was a shoddy repair there.




You can see from the pictures how it curves in right about as it's about to get to the door. Is there any way to remove that? There is still space between the patch panel, so I'm not sure if that did it. As well, I have cut the inner brace out of the back, so I'd like to remove this curve before I weld that brace back up (No, the brace doesn't affect this bulge, unfortunately, or my problems would be over!)

Suggestions? Thanks guys!