I am a novice in the purest form with it comes to pulling dents. I bought the stinger from Len a long time ago. I now have a chance to use it.
I took a piece of a hood I had laying around and took a hammer to it and made a moderate dent. I ground it down to metal and commenced welding studs. That was the fun part. The studs that held the best were the ones that BURNED A HOLE CLEAR THROUGH THE METAL! Now from my little knowledge, that is not supposed to happen.
I really don't think that I held that tip on for more than 1second. The area around these studs looked like a perfect burned area. Any ideas on what I may be doing wrong? If I can't get this figured out I am going to pass on the job.
And, how do you keep a door panel from bursting into flames with this thing? I was amazed at how hot that thing got.