Search:

Len, thanks as always.

What size metal would I buy to replace the area around the back window? Also what size would i use for the bottom of fenders, and for patching up holes where i removed the...

sorry these are the back window pictures flipped so you can view it better (left and right side of back window)

Pics of the back window

I'm a beginner and trying to find the best way to repair the rust around my front and back window. I've never welded before but I do have a Lincoln 140 MIG welder. So far I've removed the front...

I'm getting ready to begin priming my car, but I only have a medium reducer. What would be the affects of my prime job if the metal is colder than the recommended temperture for the reducer?

Thanks Len.

The instructions stated that it was intentionally left loose so the packing does not take a "set" before the spray gun is used. This is my first time purchasing a paint gun so I had no...

I just purchased the FLG3 and received it today. My question is with the packing nut.

The instructions state
1. Tighten packing nut until fluid needle starts to bind in the packing.
2. ...

Tomsteve,

I'm just getting started with automotive paint. I didnt know there was a way to cool the air. I'm interested in hearing how I can do this. For the moisture I was planning on putting a...

Perfect so sounds like I can get the SRi pro if I can do a panel at a time for primer with my compressor and then have a good enough gun to take to the booth for the entire job. The information you...

Thanks a lot Len for the advice. Honestly these were the guns I was thinking about buying for now, but I plan to get either the Tekna or Pro for my base/clear coat as I will be renting a paint booth...

I have a DeWALT 120 volt, 15 gallon, 200 PSI, 5.4 SCFM Compressor. I know my compressor is no where near what I need to be painting cars. I'm looking for a gun that I can use to spray epoxy primer....