TheCoatingStore.com

Search:

Type: Posts; User: Phil V

Page 1 of 2 1 2

Search: Search took 0.16 seconds.

  1. Replies
    17
    Views
    2,056

    Personally I think he needs at least two...

    Personally I think he needs at least two different spray guns for different purposes. You don't haul a yard of landscaping gravel in your family sedan and you don't take out a new girlfriend on a...
  2. Replies
    17
    Views
    215

    You are not going to be able to feather edge that...

    You are not going to be able to feather edge that clear without damaging the silver or the black paint.

    I assumed that 2" scratch was just a scuff that could be polished out, based on what I...
  3. Replies
    17
    Views
    2,056

    Your compressor won't put out enough air to paint...

    Your compressor won't put out enough air to paint anything much better than a car door. The average HVLP spray gun can use upwards of 15 cfm. That's close to three times the amount of air your air...
  4. Replies
    17
    Views
    215

    I think that could be repaired. You would have...

    I think that could be repaired. You would have to widen the black line a little bit but if done right with the right taper the repair would be close to invisible. If the existing black lines were...
  5. Replies
    17
    Views
    215

    One main contributor to visible paint edges is...

    One main contributor to visible paint edges is the amount of paint sprayed in that area. In other words the more paint build up you spray the more pronounced the visible paint edge will be. Moral...
  6. Replies
    17
    Views
    2,056

    quote -- "This gun is a buy it for life choice...

    quote -- "This gun is a buy it for life choice for me."

    No one is flaming your or getting on your case, we just need to clear up some potential pitfalls of your spray gun plan. You can't buy a...
  7. Replies
    41
    Views
    519

    i have seen people say " use air pressure in the...

    i have seen people say " use air pressure in the tank from an air hose/nozzle to push the dents out and I'm here to tell you DON'T DO IT. You will blow out the seams before the dents pop out. ...
Results 1 to 7 of 100
Page 1 of 2 1 2