Search:

It was CRAIGSLIST and it's not a business ad. It's sidework!

It's not a big deal to me unless Jayson is saying this car is going to the mags or plaques are made or I can't make it as straight. I'm...

swallow your pride Jayson and look at the other pics. If you look at them and say I can't make it as straight your smoking crack

Whatever though. I'll take it off so you can enjoy your notoriety.

I gotta disagree with the overkill part. Check the link I left up above and it mentions that N masks aren't as effective after usage, which means the p lasts longer. If you're talking $5 bucks for a...

I figured out that part of it but I don't have enough exp with paint to know how subtle or not the varriances are from code. My only exp was with deltron toners and a scale and I noticed the whites...

I usually never take anything I can't handle but I fricken need some money and a guy contacted me about dealership work, which would be a bunch of spot jobs I'm assuming. Anyhow, I don't have much...

I'd hit it with 600 wet lightly being that etch doesn't have build.

You should probably seal it too.

I think the P95/P100 are even better than the N95. They say both can be used for welding but I doubt they account for galvanized metal, which is the most dangerous thing so not sure if either is...

I haven't done any sidework that's pic worthy in over a month and I need to spice up my CL ads. Thanks for the pics! :D

that's a great informative post. Thanks for contributing that. Very non bias opinion.

and a steady hand.

laying sideways, slamming the trunk, and being black????

I don't have much custom exp but I can imagine it being a failure down the road.

yep, very toxic. Seems like even the guys that know only put on a mask when they do radiator supports. Not good enough. Better to be safe than sorry. There's this pic in my book with an exploded view...

Did you find that it doesn't cure as quickly as they say? Maybe the rock chip was to deep but I used it for one car and didn't like it. It sands nice though but if you can only use it for small rock...

you should do a back up strip method if you don't have much experience. Check the classroom section of the board and look for the rust repair on the door bottom. Also, when you fit it up take your...

you can also mask it in a way where you can make the masking easier for the paint. You just leave a small gap on your edges and mask those last so when you block you peel off the tape and just retape...

Why are you using etch? Are you planning on just keeping it primed for a later date? I'd go with epoxy instead of etch due to the acid and compatibility issues with your 2ks.