TheCoatingStore.com

Search:

Type: Posts; User: Len

Page 1 of 2 1 2

Search: Search took 3.30 seconds.

  1. Replies
    5
    Views
    63

    If the chrome is loose and will come off easily...

    If the chrome is loose and will come off easily you may be able to press on some packing tape and pull it off.
  2. Replies
    16
    Views
    8,941

    Yes, you'll want some of the base coat color,...

    Yes, you'll want some of the base coat color, clear, hardener and reducer.

    Sand off the bad paint with the 800 grit then clean and mask around the door and paint it.

    It would be best if you had...
  3. Replies
    16
    Views
    8,941

    Cars that have color and clear on them have those...

    Cars that have color and clear on them have those paints applied separately. Color that's applied using an aerosol cannot be blended into the surrounding paint properly and, like yours, won't make...
  4. Replies
    5
    Views
    63

    I'm not sure how the chrome can be removed but if...

    I'm not sure how the chrome can be removed but if you just want to paint the grill I'd probably give it a light sand blasting then spray with epoxy primer and paint. The blasting will give the...
  5. Replies
    2
    Views
    68

    It's probably ok as long as you remove the...

    It's probably ok as long as you remove the thinner quickly and allow the surface to dry. It wouldn't be safe for all painted surfaces but for you Kia it should be somewhat resistant to damage that...
  6. Replies
    2
    Views
    83

    It depends on what sealer you're using. If...

    It depends on what sealer you're using. If you're using epoxy primer as a sealer then you can just seal it wait until the sealer dries a little then spray your paint. If you're using a dedicated...
  7. Replies
    11
    Views
    405

    Nice job, looks great!

    Nice job, looks great!
  8. Thread: Aluminum Pontoons

    by Len
    Replies
    2
    Views
    48

    I would scuff it to give the metal a little...

    I would scuff it to give the metal a little tooth, spray it with a good epoxy primer and apply the paint within the recoat window of the primer.
  9. Check out the parts behind the fluid tip if...

    Check out the parts behind the fluid tip if anything is damaged it would cost around $90 to replace everything shown below. The rear most seal comes in a pack of 5 for $22 at this time.

    ...
  10. Replies
    4
    Views
    399

    Sometimes seals are damaged by soaking the gun...

    Sometimes seals are damaged by soaking the gun body in solvent when cleaning the gun. Check out the gun cleaning video at the top of the General Discussion forum. Never soak the gun body in solvent.
  11. Replies
    7
    Views
    138

    I'm assuming that you can't purchase an...

    I'm assuming that you can't purchase an aftermarket fender and if so I think I'd straighten it rather than patch it. What kind of car is it?
  12. Replies
    7
    Views
    128

    If we were doing the job we would spot weld the...

    If we were doing the job we would spot weld the center then half way to the ends then the ends then half way between the welds until the welds were about an inch apart then we would weld it solid by...
  13. Replies
    14
    Views
    2,167

    Yep it's just a link to another site, they must...

    Yep it's just a link to another site, they must have removed the content.

    As far as the Android problem I have no idea what that's all about, I'll question my host.
  14. Thread: turbine painting

    by Len
    Replies
    15
    Views
    417

    Yes, a turbine generates less overspray but more...

    Yes, a turbine generates less overspray but more orange peel. However sanding and polishing can result in a good paint job.
  15. The type of drying system depends on how much...

    The type of drying system depends on how much it's being used. The refrigerated system works well in a shop where it's used a lot and a desiccant system works well in a shop that doesn't need a lot...
Results 1 to 15 of 100
Page 1 of 2 1 2