Search:

Post is a little old for a reply , but something to think about , have you considered pumping some air into the tank ,naturally filler and any other ports will have to be plugged , use a regulator to...

Have you tried Wax and Grease remover , shouldn't cause any top coat problems either , Frank

I have always used a product very similar to this , after glass was installed ,Rubber mount or Glue in , I always used a tube of this non hardening sealer , then worked it around with a glazing stick...

You got 98% (47 right out of 48). The average score is 73% Frank T maybe I'm just a little older or a better memory !

how about this one

http://portland.craigslist.org/clc/tls/2511590650.html

I agree with the other poster said , if your not in a big hurry you will find them on Craigslist from time to time , also check the link that they can be bought new for $ 750. , no bottle naturally...

cyber weld , on eliizabeth ave , linden nj ph# 908 486 9366 they claim they have it ,, Frank

http://store.cyberweld.com/hob21bgaswir1.html

I can't speak for your area , but here in Florida , pick up take off beds are a dime a dozen , all colors I might add , reason being the take off the factory box and either install rack bodies or...

Sorry Dave , but I would go with .023 wire , less amps = less heat == less distorition, see link below- Frank T
http://www.millerwelds.com/resources/articles/index?page=articles37.html

88GT Not that its likely I'll have to comply in my lifetime, what would it take to switch over to water borne? What new equipment would I need? I'll probably spray solvent until I give it up...

Len , talking to a close friend there in your state , he just told me that you will have to go green , he has switched from Parrot Paint , [ Glasurit} urethane to PPG waterborne , and prefers that...

J EARLY , have you looked into GLASURIT paint products , in my opinion I believe they are superior- Frank T

like Mike said , some patch pieces ,back it up with a piece of flattened copper tubing to suck some heat out , the smaller holes I was thinking of that rod that works with a propane tank , by chance...

MattC, if that is what your main thing is those floor pans or light ga. sheet metal , I would really look into a 110 or a small 220v mig welder , and .023 I believe is the thinest wire , you are...

I just found this on craigslist near you , Frank

http://syracuse.craigslist.org/tls/1428934497.html

MATTC, get yourself some scrap pieces of flat stock , 1/8, or 3/16 , with 1/16 rod try 70 /80 amps , slide the rod on the metal about 45 degree angle like you were going to light a match , not fast,...

A2ct/W, beautiful job , pictures are great quality, the right mirror is facing the ground are you watching for flames out the tail pipes, lol - Frank

If it were me I would buy a Lenco spot welder , a few dollars more but a more versitle machine , they have been around the auto body trade for years , a very well constructed machine not a toy , but...

52 wrench, just how lite is the lite weight camper , reason being , I am not going to assume that you should know not exceed the payload capacity of the truck , ie f-150 = 1000lbs , the reason I am...

52wrench, if you plan on priming it 220 grit would be OK , if the paint is that good , I would go with 320 grit to scuff it with , be sure you remove all wax and or grease first , I like to use those...