TheCoatingStore.com

Tab Content
  • jake_h's Avatar
    Yesterday, 08:10 AM
    Thanks, Len. The fact is, I knew what was wrong with it before asking, but was trying to give as little information/bias as possible, to try and...
    7 replies | 87 view(s)
  • jake_h's Avatar
    07-12-2020, 04:44 PM
    This is where I'm at. Sanding the surface "smooth" revealed heavy ridges/peel in the previous coats. I could see some texture in the surfacer when...
    7 replies | 87 view(s)
  • jake_h's Avatar
    07-12-2020, 10:02 AM
    And I should have been more specific about what the "issue" is: heavy orange peel. Sanding the surface to the point of feeling smooth began revealing...
    7 replies | 87 view(s)
  • jake_h's Avatar
    07-12-2020, 09:39 AM
    That's a close up after sanding the orange peel "smooth." Probably no more than a 4" square area.
    7 replies | 87 view(s)
  • jake_h's Avatar
    07-12-2020, 06:43 AM
    Attached (hopefully) is a picture of a piece after the finish was sanded off partially. The finish in it's entirety is a layer of epoxy for a seal...
    7 replies | 87 view(s)
No More Results
About jake_h

Basic Information

Statistics


Total Posts
Total Posts
52
Posts Per Day
0.10
General Information
Last Activity
Yesterday 08:10 AM
Join Date
01-31-2019
Referrals
0