Tab Content
  • Bob K's Avatar
    03-19-2017, 11:17 PM
    Talk about not understanding, man you CAN breath through the straw when you have a 100 PSI at the end of the straw pushing the air in. YOU don't get...
    67 replies | 856 view(s)
  • Bob K's Avatar
    03-15-2017, 03:14 PM
    If it were at my house I would weld the head of a 5/8" bolt maybe 4" long to the center of the dent. Then take a 2" section of 2" or 3" schedule 80...
    2 replies | 70 view(s)
  • Bob K's Avatar
    03-13-2017, 12:26 AM
    Sorry, e-tek, I can't help but ask, are you anywhere near Dog River (Rouleau)? I loved that show, Corner Gas. I'm sure I watched every episode three...
    9 replies | 546 view(s)
  • Bob K's Avatar
    03-10-2017, 02:04 PM
    Bob K replied to a thread Tri coat in General Discussion
    I wouldn't be worried about smooth with this coat because of the reason they ask you to use a 1.8 tip. The product has chunks built into it that are...
    5 replies | 204 view(s)
  • Bob K's Avatar
    03-08-2017, 03:29 PM
    It's not an earth shaking problem but when you sand into the base coat you remove the barrier that the clear coat provides. You can remedy that by...
    22 replies | 1651 view(s)
  • Bob K's Avatar
    03-08-2017, 11:25 AM
    Bob K replied to a thread OOOOpppppsssss in General Discussion
    My first impression is you don't need a five minute declaration naming the paint you should use but you need a books worth of knowledge to evaluate...
    4 replies | 242 view(s)
No More Results
About Bob K

Basic Information


Total Posts
Total Posts
Posts Per Day
General Information
Last Activity
Today 11:41 AM
Join Date