Tab Content
  • bmarler's Avatar
    05-26-2017, 10:26 AM
    thanks for the tips. i have 4 full coats on this project, so no problem with film thickness. i'm just a bit nervous about the sanding part, i don't...
    62 replies | 2158 view(s)
  • bmarler's Avatar
    05-25-2017, 08:46 AM
    looks terrific, nice job. share a bit of technique with me. i'm getting ready to sand and buff one of my cars. there are quite a few body lines and...
    62 replies | 2158 view(s)
  • bmarler's Avatar
    05-24-2017, 09:18 AM
    bmarler replied to a thread Welding help in General Discussion
    when you weld you deposit molten metal on the workpiece. when the weld cools the molten metal shrinks, thats why it pulls the workpiece out of shape....
    3 replies | 133 view(s)
  • bmarler's Avatar
    05-21-2017, 08:57 AM
    transtar 7344 is not an epoxy, its a dtm urethane primer. if you want to use transtar, you should be looking at 6134 or similar. this uses 6144...
    9 replies | 220 view(s)
  • bmarler's Avatar
    05-10-2017, 10:17 AM
    only way i can think of to make that metal move back to shape would be to heat it. get it red and tap it back into position using a drift shaped to...
    3 replies | 262 view(s)
  • bmarler's Avatar
    05-05-2017, 09:59 AM
    that's interesting. where i'm at it's rarely above 80. i've always used medium reducer and just try not to paint when it's too warm. i might try slow...
    17 replies | 530 view(s)
  • bmarler's Avatar
    05-04-2017, 09:29 AM
    so, no painting between 75-80 degrees.;)
    17 replies | 530 view(s)
No More Results
About bmarler

Basic Information

About bmarler
currently restoring old lancias. pretty smart huh?


b marler


Total Posts
Total Posts
Posts Per Day
General Information
Last Activity
Yesterday 08:52 AM
Join Date