Tab Content
  • bmarler's Avatar
    Yesterday, 10:26 AM
    thanks for the tips. i have 4 full coats on this project, so no problem with film thickness. i'm just a bit nervous about the sanding part, i don't...
    62 replies | 2074 view(s)
  • bmarler's Avatar
    05-25-2017, 08:46 AM
    looks terrific, nice job. share a bit of technique with me. i'm getting ready to sand and buff one of my cars. there are quite a few body lines and...
    62 replies | 2074 view(s)
  • bmarler's Avatar
    05-24-2017, 09:18 AM
    bmarler replied to a thread Welding help in General Discussion
    when you weld you deposit molten metal on the workpiece. when the weld cools the molten metal shrinks, thats why it pulls the workpiece out of shape....
    3 replies | 121 view(s)
  • bmarler's Avatar
    05-21-2017, 08:57 AM
    transtar 7344 is not an epoxy, its a dtm urethane primer. if you want to use transtar, you should be looking at 6134 or similar. this uses 6144...
    9 replies | 202 view(s)
  • bmarler's Avatar
    05-10-2017, 10:17 AM
    only way i can think of to make that metal move back to shape would be to heat it. get it red and tap it back into position using a drift shaped to...
    3 replies | 253 view(s)
  • bmarler's Avatar
    05-05-2017, 09:59 AM
    that's interesting. where i'm at it's rarely above 80. i've always used medium reducer and just try not to paint when it's too warm. i might try slow...
    17 replies | 515 view(s)
  • bmarler's Avatar
    05-04-2017, 09:29 AM
    so, no painting between 75-80 degrees.;)
    17 replies | 515 view(s)
No More Results
About bmarler

Basic Information

About bmarler
Biography:
currently restoring old lancias. pretty smart huh?
Location:
olympia,wa
Interests:
cars,boats,music

Signature


b marler

Statistics


Total Posts
Total Posts
175
Posts Per Day
0.14
General Information
Last Activity
Today 08:34 AM
Join Date
11-14-2013
Referrals
0