Tab Content
  • junk's Avatar
    05-17-2013, 09:50 AM
    junk replied to a thread Air compressor dryer in General Discussion
    I have a dessicant regenerative dryer for my air compressor. Basically between the compressor and the tank I have two smaller tanks. The first tank...
    see more
    6 replies | 169 view(s)
  • junk's Avatar
    05-17-2013, 09:38 AM
    junk replied to a thread Painting Hinges in General Discussion
    I tumble blasted my hinges, epoxy primed them, then went straight to base coat clear coat. I myself don't like extra coats of stuff on hinges. I...
    see more
    2 replies | 94 view(s)
  • junk's Avatar
    05-13-2013, 12:08 PM
    junk replied to a thread My new project in Vans and Trucks
    My little brother just picked up one of those blazers. Nice little rigs. I was really impressed with it. Yeah straight frame is a necessity. If it...
    see more
    2 replies | 116 view(s)
  • junk's Avatar
    05-07-2013, 10:53 PM
    junk replied to a thread bubbles on fender of truck after repair and painting in Vans and Trucks
    Rear box side on the truck? I'm going with rust also sorry to say. Unless they had some weird adhesion issue, but my money is rust popping through...
    see more
    8 replies | 148 view(s)
  • junk's Avatar
    04-30-2013, 12:35 PM
    junk replied to a thread Minimum Coats of Base in General Discussion
    I found omni coverage to be poor also. Green in omni was always the worst for me. I also typically apply one more coat than when I think I have full...
    see more
    4 replies | 223 view(s)
No More Results
About junk

Basic Information

Signature


Avid collector of rust!

Statistics


Total Posts
Total Posts
273
Posts Per Day
0.53
General Information
Last Activity
Today 09:15 AM
Join Date
12-22-2011
Referrals
0