TheCoatingStore.com
Tab Content
  • 68ragtop's Avatar
    07-11-2018, 01:40 PM
    IMO The only time a D/A should be used is when your stripping off old paint, or final color sanding above 1500. I personally would not move out of...
    32 replies | 458 view(s)
  • 68ragtop's Avatar
    07-11-2018, 08:19 AM
    This is probably thinking a little too basic here on the original question, but is it possible tbs1987 was talking about what a lot of BC paints do...
    31 replies | 1164 view(s)
  • 68ragtop's Avatar
    07-11-2018, 08:00 AM
    Len, Have you ever poured a little in a cup to see if it pulls away from the sides months later? Just curious, the polyester primer I used was...
    32 replies | 458 view(s)
  • 68ragtop's Avatar
    07-11-2018, 06:58 AM
    I didn't realize "FF" was for feather fill. Is that polyester? I have never used it, I have used PPG's polyester primer in the past. Smells like...
    32 replies | 458 view(s)
  • 68ragtop's Avatar
    07-10-2018, 03:26 PM
    Looking good! I missed the part of putting black primer on top as a guide on top. Years ago I used to spray my surface primer on, then add a...
    32 replies | 458 view(s)
  • 68ragtop's Avatar
    07-10-2018, 05:52 AM
    Looking good! I would take your time with the 180-220. IMO, I wouldn't leave that grit until you can make nice easy, light pressure passes over...
    32 replies | 458 view(s)
  • 68ragtop's Avatar
    07-02-2018, 11:01 AM
    Haha, someone to share my mental lunacy with. :D This fascination for me started when I installed about 20 fluorescent lights on my walls in...
    9 replies | 246 view(s)
  • 68ragtop's Avatar
    07-01-2018, 03:48 PM
    yep, I agree. just wasn't what I was asking. :) The one advantage however could be if there was something slightly off underneath, 320 could...
    9 replies | 246 view(s)
  • 68ragtop's Avatar
    07-01-2018, 01:41 PM
    Very true, I should have mentioned at least 3 coats of high solids. I have become obsessed with making clear flatter than flat & have gotten pretty...
    9 replies | 246 view(s)
  • 68ragtop's Avatar
    07-01-2018, 08:28 AM
    Totally agree Len, I guess my pondering was more for the discussion of how deep of scratch could a person fill with clear on clear. 320? ...
    9 replies | 246 view(s)
  • 68ragtop's Avatar
    07-01-2018, 06:08 AM
    I was going to add a comment to the last thread were you guys where talking about 1000G final sand being too fine to bc or CC over the top of for...
    9 replies | 246 view(s)
No More Results
About 68ragtop

Basic Information

Statistics


Total Posts
Total Posts
725
Posts Per Day
0.17
General Information
Last Activity
Yesterday 05:46 AM
Join Date
09-17-2006
Referrals
0