Forum: Rust Repair

http://picasaweb.google.com/John.Mantooth/63Thunderbird?feat=directlink I am trying to restore a 1963 thunderbird. as you can see the rear of the...

I saw some videos on youtube and they came in handy. This c10 isn't due for 3 months but I got started cause lately all I've been doing is sanding on...

Hello all. Looks like I will need to go for inner as well as outer rocker panels plus partial floors on my '67 . Was wondering if anyone had some...

Greetings from Downunder. I have recently acquired an '86 KB Holden Rodeo and want to treat what is mostly surface rust on the frame with a view...

I plan on spraying the trunk and behind quarters. I'll probably brush it on behind doors too. I'll rustmort it first after a good sanding. Just...

I hear these mess up the door gap. Do you guys agree? If so is there a certain brand that's good? Never did a skin before but might try it out....

This area right here was under lots of sealer or something that looked like the inside of a mars bar. ...

This is my first post fellas and I would like to know if I am waaaay off base here. It seems that some of the hobby guys out there thing nothing but...

:)I have a new project,for myself this time. I have a 68` Plymouth that came from the south its REALLY good except for the lap joint where the...

Hi. I’ve been lurking for a while. I registered some time ago but I’m not sure if I ever posted here! I’ve searched both the store and the forum...

This is not the picture of the actual car. This is a picture of another G-body. I need to repair a 87 Monte Carlo SS. There are rust holes very large...

I have been trying to find the best course of action to repair this section on my Charger... there are some rusted out holes along the channel of the...

Is having the body dipped the only way? Im mostly concerned with removing the rust on the back sides of panels, seams and in the areas the you just...

I bought lower rear 1/4 panels for my 68 charger project. On the first one I decided to use the entire replacement panel and cut out the bottom 12-14...

Is there something that will brush on and protect the weld from rust? I can't get anything in the area to spray any primer. thanks tcoop

got a 66 mustang, floor boards seem solid for the most part. I would like to treat them though, inside and out. Can I use Picklex and then something...

It's a 65 mustang. For the wheelhouse I'll use heat and scrapers as I hear that's the best way. What about for behind fenders and quarters? Is it too...

In Lens Door Rust Repair "how to" he shows/recommends a brush on epoxy primer over the bottom of the door panel that was installed...Maybe Len or...

Anyone familiar with, or have any experience using, the product Rust Doctor. Someone was telling me about it. Sounds like it is a rust converter and...

After doing a ton of tack welds around a patch, is it OK to fill the small gaps with JB or some kind of metal patch chemical. Will it be a problem...