Forum: Rust Repair

I'm having a time getting this full rocker molding removed from a 2002 Grand AM. I have all the screw fasteners out, only the push plug types are...

Greeting to all. I will try to make this as short as I can. Three years in to the build and the guy who was going to replace the quarters and paint...

I have used Zero Rust's Prep Step as a cleaner and pre paint conditioner on projects like repainting light poles and water tanks. You spray it on,...

working on a 02 grand am coupe. It has rust on both pass and driver, just above the rocker trim in front of rear wheels. Anyone know a source for...

Hi, I had to fabricate and weld patches to repair the rocker panel on my '54 Bel-Air. I put too much heat into the original rocker panel while...

Hey all, My dad has an old Alfa Romeo GTV (1972?) that he dismantled 20 years ago when I was just a baby and has been working on since then. He...

So last year around this time (summer), I stripped my car and put primer back on, prepped, hand sanded (200grit I think) and than re-primered and...

i just boght this 82 regal very clean low miles and the body is decent but the top of the car is completely rusted this is my first time doing body...

Really nice body on this 73 Roadrunner other than this in driver side jamb. How is this repaired properly ? What caused it ? Any other issues I...

Len, I am new to the forum and have this new post -- although it is related to several of your very informative threads on Picklex20 and Zero Rust...

Seems like 18 gauge would be right but not sure. Hardware stores only care 16 and 22 gauge. Would like to get the real deal for now on and stop...

I hate the task myself. I recall Sam saying a cutt off wheel and then a die grinder, which made a bunch of sense but I noticed it's kind of risky...

Here’s that door opening/dog leg. I did some exploratory grinding. Actuall it’s not a sbad as I thought but it sure is bad enough! Funny, when I...

I've had success with being light and quick with a good amount of heat with a tad more wire than usual but this would be my initial welds. I then...

I am working on my hood on my 68 f-100 it has small rust holes on the front seam where the FORD letters are at. I tried welding the pin holes but...

Hi -- Just a couple of questions about what to do about the rust you see in the attached pix. 1/ There's rust under the hood and under the...

I have decided to paint the inside of the bed of my truck and need some advice on prep. A buddy of mine will spray it, but I have to do all the prep...

This is my first post. I've been reading and learning here for about 2 years. everyone here is very helpful with the problems that people post. ...

‘96 Subaru Legacy Outback. What you see patched up here was previously all rusted away. There was just nothing there. I cut the rusted edges back...

I have a 82 c10 that has rust holes in the channel ( in the seam )under the cowl panel. The area cannot be access even with the hood up and and cowl...