I have a 2002 MB C204 which has rust bubbling under the paint at the bottom of all 4 doors. I live in Michigan so we are starting to get to the end...
Newbie here. I have a cowl cowl piece that I sanded down to metal and removed all the surface rust and the rust in the pits. I primed with Diamont...
I need to stop some flash rust and lighter rust until I can get to the sanding process - using an Ospho type product. I'd like to wipe the whole car...
I am in the process of stripping the paint off my car ..I am using a DA sander with 100 grit paiper.. It is working pretty well ..My question is what...
Not really rust repair, but I didn't know were else to post this. I've got a large flat aluminum hood (1980s Olds Delta 88). The hood has mounting...
First I want complement the forum and its users there is some great info here it is a real gold mine of information. My plan is to do some of the...
Hello. New poster here. Recently, I inherited my mother's pride and joy 96 VW GTI. It spent all its life in a little town in Jersey enduring the...
My 1956 Dodge was sandblasted about 5 years ago and left in bare metal with Picklex 20. I have been recoating with Picklex 20 every year and a half...
i sand blasted my gas tank straps and then after a day later rust would reappear not all over but in some pitted spots so i redid them same thing...
This guy on You Tube, Pete, claims it's better than any other seam sealer he has used. It's really cheaped compared to seam sealer. About $6 a tube....
Hey guys I am looking for some advice on the best way to fix these rust spots on the spot welds from this quarter panel being replaced. I just found...
Hello all, Yet another new guy. I've been pa-rousing the board and there seems to be a ton of knowledge here. I'm just a hobbiest and not a pro...
The guy already cut out the metal but the trunk will need backing strips cause he didn't know what he was doing when cutting. The passenger floor can...
Surface rust pits. No holes. This is the lower rear window channel on a 70 camaro. This is my thoughts por/15 the whole channel, then epoxy...
I have a project car that I am getting sick of looking at sitting in my garage. I am looking for some guidance on how to fix the rust in the...
Ok, got a 66 mustang up on blocks right now. Some rust through around the drain holes but 95% of the rest of the floor board is just surface rust,...
Question for the 60's GM restoration guys: I am ready to install my repopped trunk pan sections into my '66 Impala. The back end of the new...
I'm in the process of repairing my rear frame rail. Where I have it cut open to replace the rear section, and along the side where I removed a rusty...
I'm having a time getting this full rocker molding removed from a 2002 Grand AM. I have all the screw fasteners out, only the push plug types are...
Greeting to all. I will try to make this as short as I can. Three years in to the build and the guy who was going to replace the quarters and paint...
Use this control to limit the display of threads to those newer than the specified time frame.
Allows you to choose the data by which the thread list will be sorted.
Order threads in...
Note: when sorting by date, 'descending order' will show the newest results first.
Forum Rules
