So just before 2am I finished the primer. I have 2 coats of Epoxy sealer and 2.5 coats of 2K primer. I say 2.5 as the first coat was light,...
Im in the process of buying a 1990 Mustang notchback. It needs some body work which I capable of. But there is a dent on the roof over the passenger...
This is partial restore, partial custom, not sure which forum to go in to, so pardon me if I messed that up. I won't say that I am having trouble,...
Guys, I am wondering on how to recreate the popcorn looking paint on the lower part of the vehicle. The car is an 84 VW Rabbit, the lower part of the...
So I went out and got me a nice stud welder to fix the dents in my targa top only to realize the top is made of Aluminum. Awesome. So I was thinking...
OK guys. So firstly I will say that I have never done any bodywork. I picked up this dodge dart for next to nothing, and I have been going back and...
In other words, taking corrosion protection and haz mat classes and any other class no one takes. For structural steel I see it's 20+ points for...
I have a 1965 dart that I saved from the crusher with the intention of doing a restoration. But, the car seems to have had a serious rear collision...
I have a 4" ST Louis Pneumatic cut-off grinder. I was cutting off the frozen sway bar link, and somehow broke the shield on the grinder. I'd like...
Good sectioning spot for a and b pillars? Anyone? I'm thinking right below the upper hinge but not sure and are you looking to go right below or...
Hey guys and girls, I'm crash it doesn't take much to figure out why.. I have an 06 toyota x runner in my drive way currently and it is pretty...
seems pretty neat. And no I'm not going to buy a $400 tool. It's either this, a rubber dolly, or a a 2x4. ...
I have a 1996 Chevy Blazer 4wd that was hit on the front passenger side frame rail(Blazer rear ended the other car), putting a crease on the frame,...
doing my first frame job and it's a total. no measuring system, no specs, but have a tram gauge and frame machine. It was hit from about the shock...
I used the 3/8" today and they're a far cry from their low end paper thin ones I've been using. It changed my mind on holesaw bits. I love them! Not...
Hello, how do I get the lid to lay flat with the body? The left side front corner is OK and the front right is high about 1/8" I have loosend the...
Just went to the other person's insurance collision place I selected based on distance to my home. Their estimate is higher than the estimate I got...
After sitting for 8 years waiting for me to get motivated, I'm starting the body repair on my 1976 Datsun 280Z. I have some rust issues to deal with,...
I need to be able to put the a new fender on my car but it's pretty badly bent. How should I go about fixing enough that I can replace the fender and...
just need it for panel separation and maybe knocking off under coating and some cutting. Not sure though. Mainly for panel separation. 3500 bpm or...
Use this control to limit the display of threads to those newer than the specified time frame.
Allows you to choose the data by which the thread list will be sorted.
Order threads in...
Note: when sorting by date, 'descending order' will show the newest results first.
Forum Rules
