View Full Version : Devilbiss GTI question
02-21-2006, 08:50 PM
I've got here a Devilbiss GTI. Problem is it doesn't say on it which GTI it is! Only other markings are PI-9Bar and "Made in England" and E9. Nozzle says No 100 HVLP 30 PSI Max Inlet E9 then the thing inside says GTI 213-14 1.4
Basically it needs a good cleaning (seems clean inside, the outside is a little messy)
Is this thing any good?
Dennis N. Schmidt
02-21-2006, 08:59 PM
It depends on the aircap the original aircap was I believe the model 100 (doing this from an aging memory) the Millennium model's aircap is the model 2000. Other than this they are identical.
Since it's made in England it's most likely one of the early models as my first GTI was made in England as well whereas my second one was made in the USA.
This is an extremely good spray gun. It's only failing is that you need a very big air compressor to adequately supply it with air as it is an absolute air hog. Anything less than 5 HP with an 80 gallon tank is a non-starter.
I believe you can just put a 2000 air cap on it. I know the 610 had the old cap and it didn't perform as well as the 620 with the 2000 air cap.
Powered by vBulletin® Version 4.2.0 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.