Fusor panel adhesive - how cold is too cold?

[novadude]

I'm planning to patch a panel using Fusor medium set panel adhesive. I cannot find any manufacturers info on suitable temperature range. My garage is around 50 deg F. Is this too cold, or can I go ahead and use the adhesive?

[Len]

If you can't get the room warmer I'd recommend that you place a light bulb (or two) close to the repair so that it warms the repair for several hours after the application of the Fusor. We keep our shop at about 55 to 60 degrees F and we use a heat lamp and a non-contact thermometer to keep the repairs at a higher temperature until they harden. A heat lamp isn't absolutely necessary and you can use a light bulb if the repair is small.

[novadude]

Thanks for the reply! Maybe I will look into a small heater or something.