PDA

View Full Version : All help Needed and Thanks!!


TheCoatingStore.com

Ranchero_65
07-06-2013, 01:55 AM
As per my other post http://autobodystore.com/forum/showthread.php?25330-10-years-ago
after getting the Ranchero in the sun well I got problems... lol A couple of nice curtins and a run or too. I set back and think about all the stupid mistakes I made but hind sight 20/20 foresight you're blind...

Need advice on how to go forth. I have read all 9 pages of this thread and got some I think but, want to be sure. I have wet paper sheets in 600, 1000,1500,2000, and disk 500, 1200,1500

The peel is there not sure what to start with thinking 800 dry 1000 dry 1500,2000 wet using da and interface pad ..
Single stage ura, been setting about a week now ..

Len
07-06-2013, 05:20 AM
Using a DA I would start with the 1500 but if the peel is bad you my want to get some 1000 to do most of the work before you get to the 1500 then go over it with 2000 or 3000 grit before buffing.

Runs are something else and should be done first, before you start sanding. In most cases we use the method outlined on the link below.


http://www.autobodystore.com/runfile.jpg
Run Repair LINK (http://www.autobodystore.com/run_repair.shtml)