PDA

View Full Version : factory orange peel matching


TheCoatingStore.com

stanclub
07-07-2011, 12:58 PM
I repainted my bumper, and the clear flows very well like the factory peel this time, but a little too shine. Should I just buff it without wet sanding? Or, I should still sand it with P1500 Trizact with interface pad? Or, skip P1500, and use P3000 Trizact as 1st cut, then buff?

I am trying to match the factory orange peel as close as possible. Thanks.

Len
07-07-2011, 01:18 PM
I repainted my bumper, and the clear flows very well like the factory peel this time, but a little too shine. Should I just buff it without wet sanding? Or, I should still sand it with P1500 Trizact with interface pad? Or, skip P1500, and use P3000 Trizact as 1st cut, then buff?

I am trying to match the orange peel as close as possible. Thanks.

If the peel is ok you can just run a buffer over it to kill some of the gloss.

Robert
07-09-2011, 06:52 PM
you could polish your car. Make the whole thing look good.